Dismantling And Assembling The Automower - Husqvarna Automower 210 C Technical Manual

5.1 Dismantling and assembling the
®
Automower
IMPORTANT INFORMATION
Clean any grass and dirt from the
Automower ® before you begin dismantling.
5.1.1 Dismantling the body
The body is screwed to the chassis with four screws,
hex 4.
Tip!
Only loosen the rear screws two turns, so that the
rear part of the body is not loosened. On the newer
models, m/2007 and beyond, the screws can be rem-
oved completely.
First clean the area around the grommet.
2. Pull out the rubber grommet on the charging
cable located at the front under the mower and
carefully loosen the connector (210 C has no
charger cable).
3. In order to completely lift off the body, the
microswitch for the stop button must also be
removed.
5.1.2 Dismantling the chassis
The chassis consists of upper and lower sections.
These are screwed together using 16 screws, torx
20. The top part of the cabling must be removed from
the control box to completely separate the parts.
5. REPAIR INSTRUCTIONS
English - 87