Using The N2818A Probe - Keysight N2818 User Manual

Using the Probe

Using the N2818A Probe

WARNING
CAUTION
CAUTION
12
Before you can use the N2818A probe, gently push the supplied hook clips
or alligator clips onto the probe leads as shown in
clips to clamp onto smaller components and the alligator clips to clamp
onto thicker gauge devices.
Must be Grounded. Before making connections to the input
leads of this probe, ensure that the probe's output connector is
attached to the channel input of the oscilloscope and the
oscilloscope is properly grounded.
To protect against electrical shock, use only the accessories supplied
with this probe or in the accessory kit.
This probe is to carry out differential measurements between two points
on the circuit under test. This probe is not for electrically insulating the
circuit under test and the measuring instrument.
Figure 5 Inserting the Supplied Clips
Figure
Keysight N2818/9A Differential Probes User Guide
5. Use the hook