Type 2A (With Chthd1 T-Harness R7) - Directed XPRESSKIT DBALL Installation Manual

Platform: DBALL/DBALL2
Firmware: CHRYSLER
Installation Type 2a (with CHTHD1 T-Harness R7)
See page 10 for
Connect for Jeep
wiring information
Commander &
Grand Cherokee only.
Parking
Lights
OR
Twisted pair in the steering column
Pink
Ignition
Barrel
(vehicle side)
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[1]
Connection only required for Jeep Commander & Jeep Grand Cherokee
[2]
Wires not listed in this diagram are not required for the installation.
All adapters are displayed from the wire side (unless specified otherwise).
or behind radio
FT CAN High: White/Orange: 5
FT CAN Low: White: 6
(AC) Tach Output: Violet/White: 5
[1]
(MUX) Parking Lights: Violet/Green: 8
(MUX) Parking Lights: Violet/Brown: 9
RAP Off: Yellow/Black: 10
(-) Driver door trigger
Violet wire in
driver kick panel or driver
door (Jeeps ONLY).
CHTHD1 R7
(optional)
12-pin Connector
(harness side)
(-) Parking Light Output
[2]
(AC) Tach Input
[1]
(+) Ignition Input/Output
White/Orange
White/Gray, White
or White/Pink
RF
DBALL/
Prog. Button
DBALL2
LED
12-pin Connector
(harness side)
(-) Ground (-) Ground
(+) 12V (+) 12V
(-) Hood Switch (-) Hood Switch
Remote Start Safety
Override Switch is inactive
(used for RSR only)
Do NOT
connect
(+)12V
RX
(-) Ground
TX
P#: XKD2D65
12-pin Connector
(Vehicle side)
© 2015 Directed. All rights reserved.
Rev.: 20150128
Page 7
D2D
only