Introduction; Contact Fluke Calibration; Remote Operation - Fluke Calibration 8588A Remote Programmer's Manual

Introduction

This document defines the remote interface commands for the Fluke Calibration
8588A Reference Multimeter and 8558A 8 ½ Digit Multimeter (the Product, DMM,
or Instrument). These commands may be used by a computer connected through
any of the remote interface ports to set settings, read measurement data, and
control the operation of the instrument. Command syntax and names follow the
IEEE-488.2 and SCPI standards.

Contact Fluke Calibration

To contact Fluke Calibration, call one of the following telephone numbers:
• Technical Support USA: 1-877-355-3225
•
Calibration/Repair USA: 1-877-355-3225
•
Canada: 1-800-36-FLUKE (1-800-363-5853)
•
Europe: +31-40-2675-200
• Japan: +81-3-6714-3114
•
Singapore: +65-6799-5566
•
China: +86-400-810-3435
•
Brazil: +55-11-3759-7600
• Anywhere in the world: +1-425-446-6110
To see product information and download the latest manual supplements, visit
Fluke Calibration's website at
To register your product, visit

Remote Operation

When the Product is operated in remote control, all local controls, except 
(Go To Local) and  are disabled.
The Product supports remote control GPIB, USBTMC-USB488, and Ethernet.
When under remote control, the state of important conditions within the Product
can be determined by reading status registers defined by IEEE488.2 and SCPI
1999.
www.flukecal.com.
http://flukecal.com/register-product.
1