Commands By Subsystem - Fluke Calibration 8588A Remote Programmer's Manual

Commands by Subsystem

Keyword
CALCulate
CALCulate:AVERage
:STATe<boolean>
:STATe?
:COUNt<nrf>
:COUNt?
:TCONtrol MOVing|REPeat
:TCONtrol?
CALCulate:LIMit
:CLEar:[IMMediate]
:LOWer <nrf>
:LOWer?
:LOWer:STATe<boolean>
:LOWer:STATe?
:FAIL?
[:STATe]<boolean>
[:STATe]?
:UPPer <nrf>
:UPPer?
:UPPer:STATe <boolean>
:UPPer:STATe?
CALCulate:MATH
:CFACtor <nrf>|LREading
:CFACtor?
:CFACtor:STATe <boolean>
CFACtor:STATe?
:MFACtor <nrf>|LREading
:MFACtor?
:MFACtor:STATe <boolean>
:MFACtor:STATe?
Table 6. Command Summary
AVER controls values displayed and returned by FETCH?
Turns State ON or OFF. Default OFF.
Return the state of AVERage
Set the number in an AVERage. Default 16, Min 1, Max 10,000.
Returns the number of readings averaged
MOVing = rolling; REPeat = Block. Default MOVing.
Returns the control setting (MOV or REP)
immediately clear all flags
Set the lower limit. Default -1.99999999e+15
Return the ower limit value
Turn the lower limit ON or OFF. Default OFF.
Return the lower limit state
Returns: Outside limits = 1, within limits = 0
Turn Limits ON or OFF. Default OFF.
Return the limits state
Set the upper limit. Default +1.999999999e
Return the lower limit value
Turn the upper limit ON or OFF. OFF.
Return the upper limit state
Math calculates (mx - c)/z
Sets the c variable to a value or the last reading. Default 1, Min -
9.9E+37, Max 9.9E+37.
Returns the c variable value
Turns the - c operation ON or OFF. Default OFF.
Returns the state of c operation (I = On, 0 = Off)
Sets the m variable to a value or the last reading. Default 1, min
-9.9E+37, Max 9.9E+37.
Returns the m variable value
Turns the multiply by m operation ON or OFF. Default OFF.
Returns the state of m operation (I = On, 0 = Off)
Reference Multimeter and 8 ½ Digit Multimeter
Description
SCPI Commands Reference
19