Fluke Calibration 8588A Remote Programmer's Manual page 39

Keyword
:SECondary?
SECondary:METHod
MEASure|SINE|SQUare|TRIangle|TSINe
:SECondary:METHod?
[:SENSe]:VOLTage:DC
:APERture <nrf>|MIN|MAX|DEF
:APERture? [MIN|MAX|DEF]
:APERture:MODE AUTO|FAST|MANual
:APERture:MODE?
:NPLC <plcs>MIN|MAX|DEF
:NPLC? [MIN|MAX|DEF]
:IMPedance AUTO|1M|10M
:IMPedance?
:RANGe:AUTO[:STATe] <boolean>
:RANGe:AUTO[:STATe]?
:RANGe <nrf>|MIN|MAX|DEF
Table 6. Command Summary (cont.)
Returns the selected secondary reading setting
Set the method by which the secondary peak-to-peak value is
calculated
MEASured = The measured positive peak minus the measured
negative peak value
SINe = The peak to peak of a sine wave calculated from the rms
value
SQUare = The peak to peak of a square wave calculated from
the rms value
TRIange = The peak to peak of a triangle waveform calculated
from the rms value
TRUNcated = The peak to peak of a truncated sine wave
calculated from the rms value
Returns the method by which the secondary peak-to-peak value
is calculated
Sets the ADC aperture value in seconds or to the MIN, MAX, or
Default setting
Returns the aperture setting or the MIN, MAX, or Default
settings in seconds
Sets the aperture mode
Returns the aperture mode
Sets the ADC aperture in number of power line cycles or to the
MIN, MAX, or Default plc setting
Returns the ADC aperture in number of power line cycles or to
the MIN, MAX, or Default plc setting
Sets the input impedance. Auto is > 1 T Ω if range is < 100 V,
otherwise 10 MΩ
Returns the input impedance setting
Turns Auto range ON or OFF
Returns 1 for Auto range ON, 0 for auto range OFF
Set maximum expected value or min, max or default range
Reference Multimeter and 8 ½ Digit Multimeter
Description
SCPI Commands Reference
35