Fluke Calibration 8588A Remote Programmer's Manual page 18

8588A/8558A
Remote Programmer's Manual
In the command set below, the short form of parameters MINimum, MAXimum
and DEFault are used for brevity, the long form can be used if preferred.
CONFig:<meter_fn>
:CONFigure:CAPacitance
:CONFigure:CURRent:AC
:CONFigure:CURRent:DC
:CONFigure:XCURrent:AC
:CONFigure:XCURrent:DC
:CONFigure:VOLTage:AC
:CONFigure:VOLTage:DC
:CONFigure:RESistance
:CONFigure:FRESistance
:CONFigure:FREQuency
:CONFigure:PERiod
:CONFigure:POWer
:CONFigure:TEMPerature[:TRANsducer]:TCouple
:CONFigure:TEMPerature[:TRANsducer]:RTD
:CONFigure:TEMPerature[:TRANsducer]:TRTD
:CONFigure:TEMPerature[:TRANsducer]:FRTD
CONFigure?
Notes for These Commands
Note 1:
CONFigure:<meter_fn> <parameters> forces the trigger system state to:
•
•
•
•
•
•
•
•
•
•
•
14
INITiate:CONTinuous OFF
ARM:LAYer2:SOURce IMMediate
ARM:LAYer2:DELay 0 (ARM2:DELay:AUTo is set to OFF)
ARM:LAYer2:COUNt 1
ARM:LAYer1:SOURce IMMediate
ARM:LAYer1:COUNt 1
ARM:LAYer1:DELay 0 (ARM2:DELay:AUTo is set to OFF)
TRIGger:SOURce IMMediate
TRIGger:COUNt 1
TRIGger:DELay 0.0 (TRIGger:DELAY:AUTO is set to OFF)
TRIGger:HOLDoff AUTO
<parameters>
[<range>|MIN|MAX|DEF [,<resolution>|MIN|MAX|DEF]]
[<range>|MIN|MAX|DEF [,<resolution>|MIN|MAX|DEF]]
[<range>|MIN|MAX|DEF [,<resolution>|MIN|MAX|DEF]]
[<range>|MIN|MAX|DEF [,<resolution>|MIN|MAX|DEF]]
[<range>|MIN|MAX|DEF [,<resolution>|MIN|MAX|DEF]]
[<range>|MIN|MAX|DEF [,<resolution>|MIN|MAX|DEF]]
[<range>|MIN|MAX|DEF [,<resolution>|MIN|MAX|DEF]]
[<range>|MIN|MAX|DEF [,<resolution>|MIN|MAX|DEF]]
[<range>|MIN|MAX|DEF [,<resolution>|MIN|MAX|DEF]]
[DEFault[,gate_time|MIN|MAX|DEF]]
[DEFault[,gate_time|MIN|MAX|DEF]]
no parameters
[<type>[,DEFault[,<resolution>|MIN|MAX|DEF]]]
[<DEFault >[,DEFault[,<resolution>|MIN|MAX|DEF]]]
[<DEFault >[,DEFault[,<resolution>|MIN|MAX|DEF]]]
[<DEFault >[,DEFault[,<resolution>|MIN|MAX|DEF]]]
Returns the setup configured by the last CONFigure or
MEASure? See Note [6].