Fluke Calibration 8588A Remote Programmer's Manual page 27

Keyword
:TOUTput
OFF|ACO|APE|BCO|EVE|RCO
:TOUTput?
:TOUTput:ONCe
:TOUTput:SLOPe POSitive|NEGative
:TOUTput:SLOPe?
:TERMinals
FRONt|REAR|SCAN|ISOLated
:TERMinals?
SENSe Subsystem
Note: In the SENSe subsystem tables below, the short form of parameters is used (for example, DEF for
DEFault). The long form may be used if preferred. Default settings are at the end of the Sense summary
table.
[:SENSe]:CAPacitance
:LOWI[:STATe] <boolean>
:LOWI[:STATe]?
:RANGe:AUTO[:STATe] <boolean>
:RANGe:AUTO[:STATe] ?
:RANGe <range>|MIN|MAX|DEF
:RANGe? [MIN|MAX|DEF]
:RESolution <nrf>|MIN|MAX|DEF
:RESolution? [MIN|MAX|DEF]
Table 6. Command Summary (cont.)
Configures the rear panel TRIG OUT waveform. Default ACO.
OFF = Pulses disabled
ACO = Pulse at end of acquisition, start of run down
APE = Squarewave active during acquisition
BCO = Multiple reading burst complete
EVE = Limit exceeded
RCO = ADC conversion complete
Returns the rear panel TRIG OUT setting
Causes a single pulse from the rear panel TRIG OUT connector
Sets the polarity of the rear panel TRIG OUT waveform. Default
NEG
Returns the polarity of the rear panel TRIG OUT waveform
Sets the active terminals. Default FRONt .
Returns the active terminals
Selects Low current ON or OFF
Returns Capacitance Low Current mode, 0 = OFF, 1 = ON
Turns Auto range ON or OFF
Returns 1 for Auto range ON, 0 for auto range OFF
Set maximum expected value or min, max, or default range
Returns the selected range or, or if specified, the minimum,
maximum or default range
Set maximum expected value or min, max or default resolution;
for example, range is 10 µF, Resolution <nrf>. = 0.000000001
(1 nF), the measurement is returned with a resolution of
+1.000E-9
Returns the selected resolution, or, if specified, the minimum,
maximum or default range
Reference Multimeter and 8 ½ Digit Multimeter
Description
SCPI Commands Reference
23