Fluke Calibration 8588A Remote Programmer's Manual page 36

8588A/8558A
Remote Programmer's Manual
:RANGe:AUTO[:STATe] <boolean>
:RANGe:AUTO[:STATe]?
:RANGe <range>|MIN|MAX|DEF
:RANGe? [MIN|MAX|DEF]
:RESolution <resolution>|MIN|MAX|DEF
:RESolution? [MIN|MAX|DEF]
:FILTer[:STATe] <boolean>
:FILTer[:STATe]?
[:SENSe]:TEMPerature:RTD|TRTD|FRTD
(RTD= 2-wire TRTD = three wire, FRTD = 4-wire Resistance temperature device)
:APERture <seconds>|MIN|MAX|DEF
:APERture? [MIN|MAX|DEF]
:APERture:MODE AUTO|FAST|MANual
:APERture:MODE?
:NPLC <plcs>|MIN|MAX|DEF
:NPLC? [MIN|MAX|DEF]
:RESistance:RO 25|100
:RESistance:RO?
:RESolution <resolution>|MIN|MAX|DEF
:RESolution? [MIN|MAX|DEF]
:SECondary[:STATe] <boolean>
:SECondary[:STATe]?
:UNITs C|CEL|F|FAR|K
:UNITs?
32
Table 6. Command Summary (cont.)
Keyword Description
Sets Auto ranging ON or OFF
Returns the Auto range setting
Sets the expected maximum input resistance, or if selected, to
the MIN, MAX, or Default setting
Returns the range setting or if selected the MIN, MAX, or
Default setting
Set maximum expected value or MIN, MAX, or Default
resolution
Returns the selected resolution, or if specified, the MIN, MAX, or
Default resolution
Turns the input filter ON or OFF
Returns the filter setting, 0 = OFF, 1 = ON
Sets the ADC aperture value in seconds or to the MIN, MAX,
or Default setting
Returns the aperture setting or the MIN, MAX, or Default
settings in seconds
Sets the aperture mode
Returns the aperture mode
Sets the ADC aperture in number of power line cycles or to
the MIN, MAX, or Default plc setting
Returns the ADC aperture in number of power line cycles or
to the MIN, MAX, or Default plc setting
Set the reference resistance value
Return the reference resistance value
Set maximum expected value or min, max or default
resolution. MAX or MIN sets resolution to maximum/minimum
appropriate to the NPLC/Aperture setting.
Returns the selected resolution, or if specified, the MIN,
MAX, or Default resolution
Turns the secondary reading (voltage) ON or OFF
Returns the state of the secondary reading (1 = ON, 0 = OFF
Set units to Celsius (C, CE), Fahrenheit (F, FAR) or Kelvin