Example: Direct Product To Controlling Computer Connection Configuration - Fluke Calibration 8588A Remote Programmer's Manual

8588A/8558A
Remote Programmer's Manual
Subnet Mask
Port
Remote Interface
EOL

Example: Direct Product to Controlling Computer Connection Configuration

Product configuration
Controlling computer configuration:
1. Right click on the Windows Start Icon and select Network Connections
2. Select Network and Sharing Center.
3. Select Change adapter settings.
4. Right click on the interface and select Properties.
5. Highlight Internet Protocol Version 4 (TCP/IPv4) and select Properties.
6. On the General tab, select Obtain an IP address automatically.
7. Select Alternative Configuration tab.
8. Select User Configured.
9. Check that communications can be established:
10. Before you proceed, set the event and status registers as required.
8
Default: 255.255.255.000
Default: 3490
Default: Computer, can be set to Terminal
Default: LF can also be set to CR CRLF
DHCP: OFF
Ethernet IP Address: 192.168.0.250
Gateway: 192.168.001.001
Subnet Mask: 255.255.255.000
Port: 3490
Remote Interface: Computer
EOL: LF
IPv4 Address:
Subnet mask:
Default Gateway:
Write *IDN?
Read the response
Clear registers
Write: *CLS;*RST
192.168.0.250
255.255.255.0
192.168.0.1