Fluke Calibration 8588A Remote Programmer's Manual page 24

8588A/8558A
Remote Programmer's Manual
:MUNits
PERCent|DB50|DB75|DB600|DB
:MUNits?
:MUNits:STATe <boolean>
:MUNits:STATe?
:STATe <Boolean>
:STATe?
:RESet
:ZFACtor <nrf>|LREading
:ZFACtor?
:ZFACtor:STATe <boolean>
:ZFACtor:STATe?
CALCulate:SSTatistics
:AVERage?
:COUNt?
:MAXimum?
:MINimum?
SDEViation [PPM]
:SDEViation?
:SPAN?
:STATe <boolean>
:STATe?
20
Table 6. Command Summary (cont.)
Keyword Description
Sets the Units for MATH calculations. Default +1.999999999e
PERCent = Units of (mx - c) in percent of z
dB50 =Relative to 1 mW in 50 Ω
dB75 =Relative to 1 mW in 75 Ω
dB600 =Relative to 1 mW in 600 Ω
dB = Relative to 1
Returns the MUNit parameter
Turns MUNits ON or OFF. Default OFF.
Returns the MUNits setting
Turn Math ON or OFF. Default OFF.
Returns the Math state
Reset Math factors to defaults
Sets the z variable to a value or the last reading. Default 1, min -
9.9E+37, Max 9.9E+37.
Returns the z variable value
Turns the - z operation ON or OFF. Default OFF.
Returns the state of z operation (I = On, 0 = Off)
Returns the count of elements in memory/record in the statistics
calculation
Returns the maximum value
Returns the minimum value
Sets the Standard Deviation value (no parameter) or Standard
Deviation in ppm
Returns the standard deviation
Retuns the span of the readings
Turns statistics state ON or OFF. Default OFF.
Returns the statistics state