Fluke Calibration 8588A Remote Programmer's Manual page 35

Keyword
:THReshold <nrf>|MIN|MAX|DEF
:THReshold? [MIN|MAX|DEF]
[:SENSe]:POWer
:AVERage <nrf>|AUTO
:AVERage?
:FREQuency <nrf>
:FREQuency?
:IDENtity?
:RELative RELative | ABSolute
:RELative?
:RELative:REFerence <value>|LReading
:RELative:REFerence?
:UNITs DBM|WATTs|VRMS|VPPK|DBUV
:UNITs?
[:SENSe]:RESistance
:APERture <seconds>|MIN|MAX|DEF
:APERture? [MIN|MAX|DEF]
:APERture:MODE AUTO|FAST|MANual
:APERture:MODE?
:NPLC <plcs>MIN|MAX|DEF
:NPLC? [MIN|MAX|DEF]
:MODE NORMal|HIV
:MODE?
:LOWI [:STATe]<boolean>
:LOWI[:STATe]?
Table 6. Command Summary (cont.)
Set Threshold to the numeric value or to the MIN, MAX, or
Default threshold setting
Return the Threshold numeric value or if specified, the MIN,
MAX, or Default threshold setting
Set the number of readings to average
Return the number of readings being averaged
Frequency at which to measure power
Returns the set power frequency
Returns the identity of the RF sensor
Selects Relative (True) or Absolute (False) measurements
Returns Relative (=1) or False (=0)
Sets the reference value or the last reading as reference for
relative measurements
Returns the reference level
Returns the selected units
Sets the ADC aperture value in seconds or to the MIN, MAX or
default setting
Returns the aperture setting or the MIN, MAX or Default settings
in seconds
Sets the aperture mode
Returns the aperture mode
Sets the ADC aperture in number of power line cycles or to the
MIN, MAX or default plc setting
Returns the ADC aperture in number of power line cycles or to
the MIN, MAX or default plc setting
Sets the 2-wire Ohms mode
Returns the 2-wire Ohms mode setting
Sets the Low current mode ON or OFF
Returns the low current mode setting
Reference Multimeter and 8 ½ Digit Multimeter
Description
SCPI Commands Reference
31