Fluke Calibration 8588A Remote Programmer's Manual page 29

Keyword
:SECondary?
:SECondary:METHod MEASure|SINE|
SQUare|TRIangle|TSINe
:SECondary:METHod?
[:SENSe]:CURRent:DC
:APERture <nrf>|MIN|MAX|DEF
:APERture? [MIN|MAX|DEF]
:APERture:MODE AUTO|FAST|MANual
:APERture:MODE?
:NPLC <plcs>MIN|MAX|DEF
:NPLC? [MIN|MAX|DEF]
:RANGe:AUTO[:STATe] <boolean>
Table 6. Command Summary (cont.)
OFF = Secondary reading is not shown
FREQuency = Secondary reading is frequency
PERiod = Secondary reading is period
PTP = Secondary reading is peak-to-peak
PPEak = Secondary reading is positive peak
NPEak = Secondary reading is negative peak
CFACtor = Secondary reading is the crest factor
Returns the selected secondary reading setting
Set the method by which the secondary peak-to-peak value is
calculated
MEASured = The measured positive peak minus the measured
negative peak value
SINe = The peak to peak of a sine wave calculated from the rms
value
SQUare = The peak to peak of a square wave calculated from
the rms value
TRIange = The peak to peak of a triangle waveform calculated
from the rms value
TRUNcated = The peak to peak of a truncated sine wave
calculated from the rms value
Returns the method by which the secondary peak-to-peak value
is calculated
Sets the ADC aperture value in seconds, or to the MIN, MAX, or
default setting
Returns the aperture setting or the MIN, MAX, or default settings
in seconds
Sets the aperture mode
Returns the aperture mode
Sets the ADC aperture in number of power line cycles or to the
MIN, MAX, or default plc setting
Returns the ADC aperture in number of power line cycles or to
the MIN, MAX, or default plc setting
Turns Auto range ON or OFF
Reference Multimeter and 8 ½ Digit Multimeter
Description
SCPI Commands Reference
25