AT&T SYSTEM 25 Manual page 69

Determining the Status of Outside Lines Associated with a FACILITY Button. The display
shows the number of busy trunks (lines) out of the total number of trunks in the group. In
the following example, five out of the 12 trunks in the group are busy.
Checking the Feature Assigned to a Button. If Inspect is used on a button other than those
previously listed, the name of the feature assigned to the button will be displayed. For
example:
Using the Inspect Feature
When using the Inspect feature, you cannot perform call-handling procedures (holding,
transferring, answering a call, etc.).
1 Press
NOTE:
2 Press the button you want to inspect.
Deactivating the Inspect Feature
When you do any of the following, you automatically deactivate the Inspect feature:
Press
[INSPECT]
Hang up the handset after being off-hook, or lift the handset after being on-hook.
Allow the display to be idle for 15 seconds.
2-56 V o i c e T e r m i n a l F e a t u r e s
005 of 012 BUSY
AUTO ANSWER
[INSPECT].
The initial display will read
INSPECT
again.