AT&T SYSTEM 25 Manual page 153

Parking a Call on the Selector Console
1
Press the Group Select and DXS buttons for one of the Park codes. For
example, if one of the Park codes is 801, press Group Select button 8 and
then press DXS button 01.
Listen for confirmation tone.
2
3 If the call is for someone else, dial or page that person. Tell the called
party the Park code on which the call is parked.
4 Hang up.
NOTE: If
is two minutes), the call will return to the
[LOOP]
If a call is parked on the Selector Console by a Switched Loop attendant
and the SLAC is placed in Position Busy mode, the parked call will return
to the other active attendant console, if not answered within two minutes.
Picking Up a Parked Call
1
Lift the handset and listen for dial tone.
2
Dial
3 Dial the PDC on which the call is parked.
SLAC
Typical Displays:
The following example is an incoming call parked on a PDC. The display shows the
characters as they are dialed to park the call.
A returning parked call is displayed on both screens.
Screen 1 indicates that the call is returning from Park.
Screen 2 identifies the source of the parked call.
3-36 Attendant Features
the parked call is not answered within a preset interval (default
button (SLAC), the same as any other unanswered call.
*5
PARK RTN
3 2 2 S i s o l a k , W p
button (DTAC) or a
[RTN-DA]
1
1