System Trace Noise (Only For Analyzers With Option 006) - HP 8753E Service Manual

11. System Trace Noise (Only for Analyzers with
Option 006)
Specifications
Frequency Range Ratio System Trace Noise System Trace Noise
30
30
1 At + 5 dBm into test port, 3 lcHz IF bandwidth, and CW
Required Equipment
Cable, APC-7, 24-inch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . HP P/N 8120-4779
Perform this test to measure the system trace noise at designated CW
frequencies in both the A/R and B/R ratioed measurements.
1. Connect the equipment as shown in Figure 2-32.
System Verification and
Performance Tests
A/R
B/R
A/R
B/R
H P 8753E
N E T W O R K A N A L Y Z E R
Figure Z-32. System Trace Noise 'Ikst Setup
sweep.