Crosstalk To Test Port 2 From 3 Ghz To 6 Ghz - HP 8753E Service Manual

18. Write the marker value (which appears on the analyzer display) in the
"Performance Test Record. n

Crosstalk to Test Port 2 from 3 GHz to 6 GHz

2. Press Ihnenu_) ~~~~~~~~ ~~~~~
3.
4. Write the marker value (which appears on the analyzer display) in the
"Performance Test Record. n
In Case of DifBculty
1. Remove the instrument top cover. Using an 8 lb-inch torque wrench, verify
that all semirigid cables connected to the sampler/mixer assemblies are
tight. In addition, tighten any loose screws on the sampler/mixer assemblies
2. Remove the instrument bottom cover. Refer to F'igure 2-26. Verify that
cables Wl, W31 and W32 are tight.
3. Repeat this test.
2-56 System Verification and
Performance Tests
. . . . . .._. _ ._ _ i . . . .
. . . . . . . . . . . . . . : . :
. . . . ~ _ ._ _ _
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..___._ -
. . . . . . . . . . . . . . . . . . / , : : . , . , ; . , . ; , . , . ; . . . . . . . . * :; .: / , , , . , . , . , .