System Verification Tests - HP 8753E Service Manual

System Verification Tests

These tests apply mainly to system-level, error-corrected verification and
troubleshooting. Tests 27 to 31 are associated with the system verification
procedure, documented in the "System Verification and Performance Tests"
chapter. Tests 32 to 43 facilitate examining the calibration coefficient arrays
(error terms) resuhing from a measurement calibration; refer to Chapter 11,
"Error Terms," for details.
27
Sys
Ver Init.
from an HP 8753E verification disk, in preparation for a measurement
calibration. It must be done before service internal tests 28, 29, 30, or
31 are performed.
28
Ver Dev 1.
#1 in aII applicable S-parameter measurements. It performs pass/fail
Iimit testing of the current measurement.
29
Ver Dev 2. Same as 28
30
Ver Dev 3. Same as 28
31
Ver Dev 4. Same as 28
32-43
array to display memory. A measurement calibration must be complete
and active. The de9nition of calibration arrays depends on the current
calibration type. After execution, the memory is automatically
displayed. Refer to Chapter 11, "Error Terms," for details.
Service Key Menus and Error Messages
above for device #2.
above for device #3.
above for device #4.
Copies error term data from a measurement calibration