Verify Intemai Tests Passed; Source - HP 8753E Service Manual

Verify Internal Tests Passed
Press
TEST
0 ALL
If your display shows the above message, go to step 2. Otherwise, continue
q
with this step.
If phase lock error messages are present, this test may stop without passing
q
or failing. In this case, continue with the next procedure to check the

source.

If you have unexpected results, or if the analyzer indicates a specific test
q
reports the Rrst failure detected. Refer to Chapter 6, "Digital Control
Troubleshooting. n
If the analyzer indicates failure but does not identify the test, press &)
q
to search for the failed test. Then refer to Chapter 6, "Digital Control
Troubleshooting." Likewise, if the response to front panel or HP-IB
commands is unexpected, troubleshoot the digital control group.
Perform the Analog
If this test fails, refer to Chapter 6, "Digital Control Troubleshooting."
q
If this test passes, continue with the next procedure to check the source.
q
Start Troubleshooting Here
. . . . .. . . . . . , . . , . . . . . . . . . _ . . / / . . . .
INT
test. Press ;.m L19] a ~~~~~~~~~~~.
Bus
PASS