Step 3. HP-IB Systems Check
Check the analyzer's HP-IB functions with a known. working passive peripheral
(such as a plotter, printer, or disk drive).
peripheral.
3. men press -~~~~~~~~~ and the appropriate softkeys to verify aat the
device addresses will be recognized by the analyzer. The factory default
addresses are:
Note
You may use other addresses with two provisions:
l
Peripheral addresses are often set with a rear panel switch.
Refer to the manual of the peripheral to read or change its
address.
4-6
Start Troubleshooting Here
Device
HP 87533
Plotter port - BP-IB
Printer port - BP-IB
Disk (external)
Controller
Power meter - I-FIB
Each device must have its own address.
recognized by the analyzer (and displayed).
HP-IB Address
16
5
1
0
21
13