If Using A Plotter Or Printer - HP 8753E Service Manual

If Using a Plotter or Printer

1. Ensure that the plotter or printer is set up correctly:
Power is on.
n
Pens and paper loaded.
n
Pinch wheels are down.
n
Some plotters need to have Pl and P2 positions set.
n
If the result is a copy of the analyzer display, the printing/plotting features
q
are functional in the analyzer. Continue with "Troubleshooting Systems
with Multiple Peripherals", "Troubleshooting Systems with Controllers", or
the "Step 4. Faulty Group Isolation" section in this chapter.
If the result is not a copy of the analyzer display, suspect the HP-IB
q
function of the analyzer. Refer to Chapter 6, "Digital Control
Troubleshooting. n
3.
Ensure that the disk drive is set up correctly:
Power is on.
n
An initialized disk in the correct drive.
n
Correct disk unit number and volume number (press ILocal) to access the
n
With hard disk (Winchester) drives, make sure the configuration switch is
n
properly set (see drive manual).
Start Troubleshooting Here