Device Verification - HP 8753E Service Manual

Device Verification

33. At the prompt, connect the 20 dI3 attenuator (supplied in the verification
kit) as shown in Figure 2-4.
If you switched OFF the record function, you have to press ~~~~~
after each S-parameter measurement.
If you switched ON the record function, the analyzer measures all
S-parameters (magnitude and phase) without pausing. Also, the analyzer
only displays and prints the PASS/FAIL information for the S-parameter
measurements that are valid for system verification.
Figure 2-4. Connections for the 20 dB Verification Device
35. When the analyzer fmishes all the measurements, connect the 50 dB
attenuator (supplied in the vetication kit), as shown in F'igure 2-5.
Performance Tests
HP R753F
N E T W O R K A N A L Y Z E R