HP 8753E Service Manual page 542

Replacement
1. Check the connector pins on the motherboard before reinstallation.
2. Slide the edges of the sheet metal partition (item 4) into the guides at the
sides of the source compartment. Press down on the module to ensure that it
is well seated in the motherboard connector.
3. Push down the retention clips Reconnect the two semirigid cables (Wl and
Note
When reconnecting semirigid cables, it is recommended that the
connections be torqued to 10 in-lb.
4. Reinstall the source bracket.
5. Reconnect the flexible cable to the B sampler.
14-24