HP 8753E Service Manual page 33

Keep connectors clean
Extend sleeve or connector nut
Use plastic end-caps during storage
Inspect all connectors carefully
Look for metal particles, scratches, and dents
Use isopropyl alcohol
Clean connector threads
Clean and zero the gage before use
Use the correct gage type
Use correct end of calibration block
Gage all connectora before first ufx
Align connectors carefully
Turn only the connector nut
Use a torque wrench for final connect
Service Equipment and Analyzer Options
Do
Do
Gaging Connectors
Do
Making conueetions
Do
Do Not
Touch mating-plane surfaces
Set connectors contact-end down
Do Not
Use a damaged connector-ever
Do Not
Use any abrasives
Get liquid into plastic support beads
Do Not
Use an out-of-spec connector
Do Not
Apply bending force to connection
Over tighten preliminary connection
Tighten past torque wrench 'break" point
I