Integrating The 3Rw5 Soft Starter Into Profibus Dp System; Integrating 3Rw5 Soft Starter Via Hsp In Step 7 (Tia Portal) - Siemens SIRIUS 3RW5 PROFIBUS Equipment Manual

Configuring
6.2 Configuring the 3RW5 Soft Starter
6.2.2

Integrating the 3RW5 Soft Starter into PROFIBUS DP system

6.2.2.1

Integrating 3RW5 soft starter via HSP in STEP 7 (TIA Portal)

Requirements
● STEP 7 (TIA Portal) as of V15 Update 3
● Hardware Support Package (HSP0238)
The current Hardware Support Package (HSP0238) can be found on the 3RW5 topic
page (https://support.industry.siemens.com/cs/ww/en/view/109747404).
Procedure
1. Install the file from the Hardware Support Package (HSP0238).
After installation, you will find the 3RW5 soft starter in the HW Catalog of STEP 7
(TIA Portal).
Note
STEP 7 (TIA Portal) as of V16
3RW5 soft starters, 3RW5 communication modules and 3RW5 HMIs are already
contained in the HW catalog of STEP 7 (TIA Portal) as of V16. Check the 3RW5 topic
page for updates and ensure that your device and the current firmware are contained in
the HW catalog.
2. Select the required 3RW5 soft starter from the HW catalog by means of the article
number.
3. Add the 3RW5 PROFIBUS communication module from the HW catalog.
4. Connect the 3RW5 PROFIBUS communication module of the 3RW5 soft starter to the
PROFIBUS DP system or the controller.
Result
The 3RW5 soft starter is integrated into the PROFIBUS DP system as a DP slave in STEP 7
(TIA Portal).
You can also integrate the 3RW5 soft starter via the GSD file in STEP 7 (TIA Portal).
(Page 69)
68
SIRIUS 3RW5 PROFIBUS communication module
Equipment Manual, 02/2020, A5E35633549002A/RS-AC/003