Disable Or Enable Group Error Via High Feature 3Rw5 Hmi - Siemens SIRIUS 3RW5 PROFIBUS Equipment Manual
Soft starters and solid-state switching devices
Hide thumbs
Also See for SIRIUS 3RW5 PROFIBUS:
- Equipment manual (214 pages) ,
- Manual (116 pages) ,
- Equipment manual (150 pages)
Table of Contents
Advertisement
Messages and diagnostics
7.6 Disable or enable group errors
7.6.1
Disable or enable group error via High Feature 3RW5 HMI
Requirements
● Access protection to 3RW5 HMI High Feature is not active or has been removed.
● They are in the following menu:
– 3RW5 HMI High Feature with firmware version earlier than V2.0:
– 3RW5 HMI High Feature as of firmware version V2.0:
● You will find more information on operating the 3RW5 HMI High Feature in the
Equipment Manual of the 3RW5 soft starter.
Procedure
1. Select the menu item "Group error".
2. Select a parameter.
– "Disable"
– "Enable" (factory setting)
3. Confirm the parameter.
Result
You have disabled or enabled transmission of the error interrupts (group error) via the
bus connection.
100
"Parameters > Communication module > PROFIBUS DP > Group diagnostics".
"Parameters > Communication module > Group diagnostics".
SIRIUS 3RW5 PROFIBUS communication module
Equipment Manual, 02/2020, A5E35633549002A/RS-AC/003
Advertisement
Table of Contents
