L3Harris narda PMM EP-600 User Manual page 65

This setting in MHz recalls the corresponding frequency correction factor
5.5.3 Frequency
stored in the EP-600/601/602/603/604 memory. It allows an extremely
correction setting
precise measurement of the field level at the selected frequency.
The graph in chapter 1 shows the correction factor in db as a function
of the working frequency.
The setting displayed at the first run is the default; the last setting will
be displayed then.
The frequency is displayed with two decimals, max. resolution of 0.01 MHz.
Press the enter key to enter the set frequency value.
Click OFF to disable the frequency correction; the button toggles to ON for
enabling the function when required.
When entering the correction frequency value or enabling the
function, the "Frequency value" will be updated according to the
Reading Time setting.
When entering the frequency correction value while in HOLD mode,
the new value will be not displayed until the HOLD is released.
The following message will appear when entering frequencies out of
the PMM EP-600/601/602/603/604 range:
WinEP600 and SetAddEP600 operating instructions 5-11