Ep600 Charger Components - L3Harris narda PMM EP-600 User Manual

4.3.2 EP600 CHARGER Description:
components
1 – Knob and Spring
2 – Charging connector
3A – Charging status Led
3B – DC Supply connector
Fig. 4-4 EP600 CHARGER components
Attempting to charging batteries of different types or dry cells may
cause explosion of the same and is strictly forbidden.
The internal battery of EP-600/601/602/603/604 can be replaced by the
Factory only. In case of failure or incorrect operation please contact
the Dealer.
The minimum voltage level for proper operation is of 2,05V; lower
voltages do require recharging the battery.
It is recommended to fully recharge the battery before long-term
storage of the probe; a full recharge shall be performed every 4
months since then.
The max. battery autonomy is of approx. 100 hours (with Filter 28 Hz
and Rate 2.5 sec), according to the filter setting.
When making measurements with PMM EP-600/601/602/603/604 the
power supply must be ALWAYS removed.
EP600 CHARGER 4-3