Ep-600/601/602/603 On Ep600 Charger - L3Harris narda PMM EP-600 User Manual

4.4 Installing EP-600/601
/EP602/603/604 on
EP600 CHARGER
4-4 EP600 CHARGER
A first complete charging cycle is recommended to achieve the max
autonomy.
To install the probe EP-600/601/602/603/604 on the battery charger EP600
CHARGER:
- place the EP600 CHARGER on a flat, stable surface
- hold and lift up the knob as shown in figure
- Insert the EP-600/601/602/603/604 on the EP600 CHARGER in
correspondence of the threaded contact pin. Do not spin the probe to avoid
damaging the contact pin.
- Release progressively the knob until rubber tip holds the EP-
600/601/602/603/604 housing downwards.
- Connect the AC adapter to the EP600 CHARGER first, then to the mains.