L3Harris narda PMM EP-600 User Manual page 35

2.10 EP-600/601/602
/603/604 installation
2.10.1 EP-600/601/
602/603/604
installation
on the conical
holder
Unexpected variations of the probe position may vary the field
measurements. Make sure the probe is steadily installed by using the
recommended standard or optional accessories.
Using the conical holder supplied with the PMM EP-600/601/602/603/604
as support for the same is essential for correct measurements.
An inadequate support might significantly influence the measurements
results; hence it is highly recommended to make use of the supplied
conical holder as support for the probe.
To mount the PMM EP-600/601/602/603/604 on the conical holder:
- place the conical holder vertical on a stable surface
- Apply the probe to the conical holder as shown in the picture, having the
fiber optic passing through the slot of the conical holder. The picture below
shows how to hold the probe between your fingers.
- Rotate the probe 45° counterclockwise:
Operation 2-7