Advertisement
Push/Pull (HPSK) Paddle Trim
ML2000 Series Mortise Lock
Installation Instructions
Mortise Lock Door Preparation & Installation
2
8. Remove lockbody from door.
9. TURN-PIECE FUNCTIONS ONLY:
Drill one middle hole (.290") and two outer holes
(3/8") halfway through door. (Figure 10)
10. COIN-TURN FUNCTIONS ONLY:
Drill two holes (1/8") halfway through door.
(Figure 11)
11. TURN-PIECE FUNCTIONS ONLY:
Install turn-piece thru-bolt plate using truss
head screw. (Leave screw slightly loose.)
(Figure 12)
NOTE:
THE THRU-BOLT PLATE IS INSTALLED INSIDE
THE DOOR POCKET .
12. Insert mortise lockbody into door and loosely
tighten 1" lock mounting combination screws.
NOTE:
MAKE SURE LOCK IS UNLOCKED . (FIGURE 13)
Strike Lip
For installation assistance contact Corbin Russwin
1-888-607-5703 • support@corbinrusswin.com
Copyright © 2017 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
MAKE SURE LOCK
IS UNLOCKED
Un-Locked
Locked
Figure 13
4
Ø3/8"
Ø.290"
Ø3/8"
Figure 10
Ø1/8"
Ø1/8"
Figure 11
Thru-bolt
Plate
Figure 12
FM339 10/18
Advertisement
