Advertisement
Push/Pull (HPSK) Paddle Trim
ML2000 Series Mortise Lock
Installation Instructions
3
HPSK Trim Installation
6. Insert mounting posts through outside
chassis then install trim on both sides of
door using mounting screws (loosely tighten
mounting screws). Make sure spindle is fully
engaged in lockbody. (Figure 19)
Spindle NOT Engaged
Spindle Engaged
7. Fully tighten 1" lock mounting combination
screws then level out chassis using a
square. (Figure 20)
NOTE:
USE SQUARE TO LEVEL OUT CHASSIS
8. Fully tighten mounting post screws.
9. Rotate cam by hand to make sure trim is not
binding - latch must project freely when cam
is released. If trim binds loosen mounting
screws and re-align trim. (Figure 21)
10. Install surface mount screws. (Figure 22)
For Wood Door:
- Drill two (2) 7/64" holes for surface mount
screws
- Install surface mount wood screws
For Metal Door:
- Drill and tap door for #8-32 screws
- Install surface mount machine screws
For installation assistance contact Corbin Russwin
1-888-607-5703 • support@corbinrusswin.com
Copyright © 2017 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
Mounting
Posts
OUTSIDE
6
Mounting
Screws
INSIDE
Figure 19
Figure 20
Figure 21
Surface Mount
Screw Holes
Figure 22
FM339 10/18
CAM
Advertisement
