Advertisement
Push/Pull (HPSK) Paddle Trim
ML2000 Series Mortise Lock
Installation Instructions
1
Mortise Lock Handing Instructions
1. Move the Red locking screw to side of lockbody
being locked.
2. Push in latch then depress catch plate with
screwdriver. (Figure 1)
3. Pull latch out of lock-body and turn latch over.
(Figure 2)
4. Push in latch while holding
screwdriver behind latch tail.
(Figure 3)
NOTE:
PUSH IN LATCH UNTIL CATCH
PLATE IS NO LONGER DEPRESSED .
(FIGURE 4)
5. Rotate lock front to match bevel of door as
shown. (Figure 5)
For installation assistance contact Corbin Russwin
1-888-607-5703 • support@corbinrusswin.com
Copyright © 2017 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
LOCK HANDING
IS CRITICAL TO
ENSURE LOCK
FUNCTIONS
PROPERLY
RED Locking Screw
MAKE SURE CATCH PLATE IS
EVEN W/ TOP SURFACE
GOOD
BAD
Figure 4
Figure 3
2
Catch Plate
Figure 1
Figure 2
WARNING:
LOCK-IN CAN
OCCUR IF LATCH
IS NOT PROPERLY
INSTALLED
Figure 5
FM339 10/18
Advertisement
