Advertisement
Push/Pull (HPSK) Paddle Trim
ML2000 Series Mortise Lock
Installation Instructions
3
HPSK Trim Installation
11. Install insert on paddle based on desired paddle
orientation. (Figure 23)
Horizontal Paddle
12. Attach paddle to chassis by aligning paddle
as shown then insert axle through pivot hole
in chassis. (Figure 24)
13. Install cover using 5/16" oval head mounting
screws. (Figure 25)
CAUTION:
- SCREWS MUST BE POSITIONED BEHIND
PADDLE TO WORK PROPERLY
- Cover will be very difficult to remove if
forced on backwards
NOTE:
COVER HOOKS UNDERNEATH CHASSIS
ON SIDE OPPOSITE MOUNTING SCREWS
14. Install scalp using 3/16" Flat Head Screws.
(Figure 26)
For installation assistance contact Corbin Russwin
1-888-607-5703 • support@corbinrusswin.com
Copyright © 2017 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
Paddle Insert
OR
=
Vertical Paddle UP
7
Paddle Insert
=
Vertical Paddle DOWN
Figure 24
Figure 25
SCALP
Figure 23
Figure 26
FM339 10/18
Advertisement
