Cutting Operations - GRAPHTEC CE LITE-50 Service Manual

9.3

Cutting Operations

Symptom
The cut line is crooked.
There is a uncut line.
The media on the corner
is turned up.
The sharpness of corner
is not enough.
The corner is too sharp.
Start and end point are
not connected.
CE LITE-UM-251-9370
Verification Items
(1) Is there any paper dust or chip
on the tip of the cutter set?
(2) Does the blade turn smoothly in
the cutter set?
(4) Do the X and Y drive belts have
the correct tension?
(1) Is the blade extended too far?
(2) Is the cutting force too low?
(3) Is the cutting speed too fast?
(1) Is the blade extended too far?
(2) Is the cutting force too high?
(3) Is the tip of the blade snapped?
(1) Is the type of the tool set
correctly on the plotter?
(2) Is the blade extended too far?
(3) Is the cutting force too high?
(4) Is the tip of the blade snapped?
(1) Is the type of the tool set
correctly on the plotter?
(1) Is there any paper dust or chip
on the tip of the cutter set?
(2) Does the blade turn smoothly in
the cutter set?
(3) Is the thick media cut?
Remove the blade cap and clean it.
Replace the cutter set.
Adjust the tension of the belt(s).
Adjust the blade length.
Adjust the cutting force.
Adjust the cutting speed.
Adjust the blade length.
Adjust the cutting force.
Replace the cutter set.
Set the tool type correct.
Adjust the blade length.
Adjust the cutting force.
Replace the cutter set.
Set the tool type correct.
Remove the blade cap and clean it.
Replace the cutter set.
Increase the offset force.
9-3
9 TROUBLESHOOTING
Solution