GRAPHTEC CE LITE-50 Service Manual page 99

(2) Attach the pinch roller to the pinch roller shaft in the correct direction.
(3) Insert the upper slide shaft to the carriage so that the D cut surface is on the left side, and then fix
it with the M3L6 TP head screw to the right side frame.
(4) Align the two bosses with the holes in the left side frame, and fix the left side frame with four M4L6
binding head screws.
Be sure to fit the slide shafts to the left side frame firmly.
(5) Tighten the M3L6 TP head screws to fix the slide shafts to the left side frame.
(6) Fix the pinch roller shaft to the left side frame with the pinch roller bush L and the E-ring.
(7) Reattach the other parts in the reverse order in which they were detached.
CE LITE-UM-251-9370
Pinch roller, left
Make the D-cut surface
positioned forward
6-81
6 DISASSEMBLY AND REASSEMBLY
Pinch roller, right