GRAPHTEC CE LITE-50 Service Manual page 76

(2) Remove the two M2L4 self-tapping screws holding the LED boards, and then detach the LED
boards from both sides of the cutting mat base.
(3) Remove the four M2L3 binding head screws holding the light bar holders on both sides of the
cutting mat base, and then detach the light bar holders.
(4) Detach the light bar from the cutting mat base.
(5) Remove the M2L5 self-tapping screw holding the light bar holder, and then detach the light bar.
Front
CE LITE-UM-251-9370
M2L4 self-tapping screws
M2L3 binding head screws
Light bar holder
6 DISASSEMBLY AND REASSEMBLY
Rear
M2L5 self-tapping screw
6-58