Power Management Display (Pmd); Mimic Diagram; Display - ABB PowerScale CABINET A User Manual

RS232 on Sub-D9 port
Customer Interfaces :
Inputs DRY PORT
RJ45 port

Power Management Display (PMD)

OPTIONAL ITEMS
Relay card + USB Including:
Customer Interfaces:
5 output DRY PORTS
RS232 on USB port
SNMP Card (
slot already included
10.8.1 POWER MANAGEMENT DISPLAY (PMD)
The user-friendly PMD consists of three parts the MIMIC DIAGRAM, CONTROL KEYS and LCD that provides the
necessary monitoring information about the UPS.

10.8.2 MIMIC DIAGRAM

The mimic diagram serves to give the general status of the UPS. The LED-indicators show the power flow status
and in the event of mains failure or load transfer from inverter to bypass and vice-versa the corresponding LED-
indicators will change colour from green (normal) to red (warning). The LED's LINE 1 (rectifier) and LINE 2
(bypass) indicate the availability of the mains power supply. The LED's INVERTER and BYPASS if green indicate
which of the two are supplying power to the critical load. The LED-indicator BATTERY is normally lit green, and
when it supplies the load is blinking. The LED-indicator ALARM is a visual indication of any internal or external
alarm condition. At the same time the audible alarm will be activated .

10.8.3 DISPLAY

The 2 x 20 character LCD simplifies the communication with the UPS. The menu driven LCD enables the access to
the EVENT REGISTER, or to monitor the input and output U, I, f, P, Autonomy Time and other Measurement's, to
perform commands like start-up and shut-down of UPS or load transfer from UPS to BYPASS and vice-versa and
finally it serves for the DIAGNOSIS (SERVICE MODE) for adjustments and testing.
For monitoring and integration in network management
1 Remote Shut down [EMERGENCY OFF (Normally closed)]
1 GEN-ON (Normally open)
1 Programmable Customer's Inputs (Normally open)
1 Temp. Sensor for Battery Control
1 12 vdc source (max. 250 mA)
For multidrop purpose
LCD display

Common alarm

Load on bypass

Battery low

Load on inverter

Mains failure
For remote signalling and automatic computer shutdown
SNMP card
)
For monitoring and integration in network management
04-3004_S10_TDS_ABB_POWERSCALE_10-50 kVA_EN_150113.doc
Printed in Switzerland – Modifications reserved
Section-10
Page 10/20 ABB