Output Dry Contact Port; Dry In; Dry Out; Network Management Card (Optional) - ABB PowerValue RT G2 User Manual

6 C O M M U N I C AT I O N
—

6 .4 Output Dry Contact Port

6 .4 .1 Dry IN

—
6.4.1-1:
Dry in allows a remote action to switch on/
Dry IN
switch off/ maintenance bypass the UPS.
—
6.4.2-1:
This is done by switching the contact from

Dry OUT

Opened to close.
—
6.4.1-1
—

6 .5 Network management card (optional)

The PowerValue 11 RT G2 5–10 kVA UL is equipped
with an intelligent slot for optional cards for
remote management of the UPS through the
Internet/ Intranet. Either of the following
accessories can be installed in the intelligent slot:
• SNMP/Modbus Card – SNMP/Modbus, HTTP
and monitoring capabilities through a Web
browser interface.
• AS400 Card – AS400 card for AS400
communication protocol.
6 .5 .1 Installing a serial network management
card (optional)
Each UPS has a communication slot for an
optional serial network management protocol
(SNMP/Modbus) card. After installing an SNMP/
Modbus card, an environmental monitoring probe
can be connected.
NOTE
 

 



THE UPS DOES NOT HAVE TO BE SHUT
DOWN BEFORE INSTALLING A
COMMUNICATION CARD.
s h u a i q i _ h e s h u a i q i _ h e s h u a i q i _ h e 2 0 2 2 - 0 2 - 1 5 s h u a i q i _ h e 2 0 2 2 - 0 2 - 1 5 2 0 2 2 - 0 2 - 1 5 2 0 2 2 - 0 2 - 1 5
6 .4 .2 Dry OUT
The dry out port is normally open. If the dry out
port is close, it indicates that the UPS is running
in summary alarm / on battery / battery low /
UPS ok / on bypass.
 

 



—
6.4.2-1
To install a network management card:
1. Remove the two screws that protect
the communication slot of the UPS.
2. Insert the SNMP/Modbus card into
the communication slot.
3. Screw the SNMP/Modbus card onto the slot
using the screws removed in Step 1
For more information on the SNMP/Modbus
Cards, see the SNMP/Modbus user's manual.

6 .5 .2 Monitoring software

The UPS can be monitored using software. The
software provides a remote and safe shutdown
for multi-client systems in case of absence of
power at the UPS output. Instructions on how to
install the software are provided with the
network management cards.
For more information, contact your local supplier.
39