Injection Screen - Siemens SIJECT 16i Operation Manual

3.2.4 Injection screen

Operating sequences
SIJECT 16i Operation Manual
Fig 3-37 Injection screen
Press Injection key to enter the injection screen. See Fig 3-37.
The system offers four Injection stages and three Pressure holding stages,
and the transition between injection and pressure holding can be selected.
On this screen, corresponding parameters can be set, such as position,
pressure, flow and time.
Injection 1 (Inject 1)
Injection 2 (Inject 2)
Injection 3 (Inject 3)
Injection 4 (Inject 4)
The time is set for the whole injection actions
Transfer mode (TraMode)
injection and pressure holding. Three modes can be selected: Position
mode, Time mode, and Position/Time mode.
Holding 1 set the pressure, flow and time for pressure holding 1.
Holding 2 set the pressure, flow and time for pressure holding 2.
Holding 3 set the pressure, flow and time for pressure holding 3.
Screw position (ScwPos)
Press Manual injection key
Decompression key
set the position, pressure and flow of injection 1.
set the position, pressure and flow of injection 2.
set the position, pressure and flow of injection 3.
set the position, pressure and flow of injection 4.
it refers to the transfer mode between
display the current position of screw.
to do injection once manually, and press
to suck back once.
SIJECT OP15B Screens
3-43