Manual Operating Keys - Siemens SIJECT 16i Operation Manual

2.4 Manual Operating Keys

General
Mold key
Ejector key
Carriage key
SIJECT 16i Operation Manual
All the manual keys
the Manual mode and Mold adjustment is running.
Press the middle Mold key to enter Mold screen.
Input corresponding parameter (Position, pressure, flow and protecting
time) for each step.
Mold will open continuously if you keep pressing the left key.
Mold will close continuously if you keep pressing the right key.
Mold close/open keys can be operated in combination with core in/out
keys; for example, "Core in" can be done during, before or after mold close,
or "Core out" during, before or after mold open.
Press the middle Ejector key to enter Ejector screen.
Now you can input corresponding parameter (Position, pressure, flow and
counter) for ejector advance and retract, and set counter and ejector mode.
Ejector will retract continuously if you keep pressing the left key.
Ejector will advance continuously if you keep pressing the right key.
Repeat above-mentioned two steps to carry out multiple ejection.
Press the middle Carriage key to enter Carriage screen.
Now you can input corresponding parameter (pressure, flow and carriage
retract time) for carriage advance and retract.
Carriage will advance continuously if you keep pressing the left key.
Carriage will retract continuously if you keep pressing the right key.
and described below can function only after
Operator panel keys
2-7