Timer Screen - Siemens SIJECT 16i Operation Manual

SIJECT OP15B Screens

3.1.5 Timer screen

Operating sequences
3-18
Fig 3-19 Timer screen
Press this key to enter the Timer screen. See Fig 3-19 Timer screen.
On this screen, the working time for every action and the delay time for
action switch, as well as protection time for charging can be set.
Cycle time (TmCyc)
actual machine cycle time is longer than the set value, then there is alarm.
Interval time (Interval)
time before the next machine cycle start. This setting is only applicable in
time auto mode.
Cooling time (TcCool)
work. This interval is to make sure that the material has enough time for
cooling.
Charging delay (TdCha)
charging, which is to prevent the overheating of plastic material.
Injection delay (TdInj)
position, it will wait certain time before injection.
Core in delay (TdCorIn)
begin after a delay time.
Core out delay (TdCorOut)
will begin after a delay time.
Ejector advance delay (TdEjeAdv)
advance will begin after a delay time.
Ejector retract delay (TdEjeRet)
ejector retract will begin after a delay time.
Mold close time (TmMldClo)
monitoring time. There is event message if the setting time is exceeded.
Mold open time (TmMldOpn)
monitoring time. There is alarm if the setting time is exceeded.
It is the time to monitor one machine cycle. If the
When one cycle is finished, there is an interval
When injection is finished, the timer begins to
It is the interval time between injection and
When the carriage arrives at the injection
When previous work is finished, core in will
When previous work is finished, core out
When mold open is ended, ejector
When ejector advance is finished,
The total time for mold close, which is
The total time for mold open, which is
SIJECT 16i Operation Manual