Table of Contents
Advertisement
Operator panel keys
Manual mode key
Mold Adjustment mode key
Run key
Stop key
2-12
This mode shall work with other manual operating keys together.
Press manual mode key and the LED is on.
In manual operating area, press the middle key to open the desired screen.
Input necessary parameters and press the manual left key or right key to
continue every action.
System will run continuously until you release the key, or when the timer or
counter is full.
Following operations can be carried out in this mode, they are:
Mold open/close; ejector advance/retract; injection/suck back; charge; core
1 in/out; core 2 in/out; core 3 in/out; air blow 1 & 2 and lubrication/purge.
This mode can also be used to reset the parameters and clear the alarm.
This mode is especially used for mold adjustment when a new mold is
installed in the machine.
Following operations can be carried out in this mode, they are:
Mold open/close; ejector advance/retract, injection/decompression, charge,
mold adjustment advance/retract and lubrication.
Press this Mold adjustment mode key and mold adjustment key
enter mold adjustment screen. Input the parameters, then press mold
adjustment advance/retract key to adjust mold manually, or press auto start
key to start auto mold adjustment.
To protect mold from damaging, the mold open/close in this mode should
keep a low speed and invariable pressure and flow.
Run key is to run Semi-Auto mode / Timer-Full-Auto mode / Sensor-Full-
Auto mode.
Stop key is to stop Semi-Auto mode / Timer-Full-Auto mode / Sensor-Full-
Auto mode.
SIJECT 16i Operation Manual
to
Advertisement
Table of Contents
