After Installation; Slot Numbers For S7 Modules - Siemens SIMATIC ET 200M Manual

Plugging in Output Modules During Operation of an ET 200M Installation
Warning
!
When you insert output modules, uncontrolled system states may occur.
This is also the case when you plug in input/output modules at an angle onto the
bus module.
When you plug in an output module, the outputs set by the user program
immediately become active!
We recommend that you set the outputs in the user program to "0" when you
remove an output module.
If modules are removed and plugged in incorrectly, neighboring modules may be
affected via the backplane bus!
4.2.4

After Installation

Assigning Slot Numbers
After installation you can assign a slot number to each module. This makes it
easier to assign the modules in the configuration table in STEP 7 or in COM
PROFIBUS. Table 4-4 shows the slot number assignment.
Table 4-4

Slot numbers for S7 modules

Slot Number
1
2
3
4
5
...
11
1
Use of the power supply is optional.
Unoccupied Slots
If you do not use all the slots in a configuration of an ET 200M with active bus
modules (perhaps reserving them for later), you must leave these slots free in the
STEP 7 and COM PROFIBUS configurations.
Distributed I/O Device ET 200M
EWA-4NEB780600602-06
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Module
1
Power supply (PS)
IM 153-x
–
1st S7-300 module
2nd S7-300 module
...
8th S7-300 module
Remarks
–
–
Not applicable
Next to the IM 153-x on the right
–
–
Installation
4-15