Siemens SIMATIC ET 200M Manual page 164

Changing Fuses
The fuses are located at the left side of the module.
1. Remove the digital output module as described in Section 7.4
2. Remove the fuse holder from the digital output module.
3. Replace the fuse.
4. Screw the fuse holder back into the digital output module.
5. Install the digital output module again (see Section 7.4).
Distributed I/O Device ET 200M
EWA-4NEB780600602-06
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Maintenance
7-15