Separating Protective Equipment; Safety Check - Optimum BF 30 Vario Operating Manual

OPTIMUM
M A S C H I N E N - G E R M A N Y
1.5.4

Separating protective equipment

Adjust the protective equipment to the
correct height before you start working.
To do so, detach the clamping screw,
adjust the required height and retighten
the clamping screw.
A switch is integrated in the fixture of the
spindle protection which monitors that the
cover is closed.
INFORMATION
YOU CANNOT START THE MACHINE IF
THE DRILL CHUCK PROTECTION IS
NOT CLOSED.
1.6

Safety check

Check the drilling-milling machine
regularly. Check all safety advices
at the beginning of each shift,
once a week (with the machine in operation),
after every maintenance and repair operation.
General check
Equipment
Protective covers
Labels,
markings
Run test
Equipment
EMERGENCY-STOP but-
ton
Separating protective
equipment around the dril-
ling and milling spindle
Page 10 Drilling-Milling machine
Check
Fitted, firmly bolted and not damaged
Installed and legible
Check
When the EMERGENCY-STOP button is activated, the drilling-
milling machine should switch off. A restart will not be possible
until the EMERGENCY-STOP button has been unlocked and the
ON switch has been activated.
Only switch on the drilling-milling machine if the protective equip-
ment is closed.
BF 30 Vario
Locking screw
Illustr. 1-4: Separating protective equipment
Version 1.0.3
Safety
OK
OK
16 / 09 / 2008