1.13
Separating protective devices
1.13.1 Protective cover of the V-belts
A protective cover for the belt
pulleys is mounted on the drill-
ing head. A switch is integrated
in the protective cover which
monitors that the cover is
closed.
INFORMATION
You cannot start the machine if
the protective cover is not
closed.
1.13.2 Drill chuck protection
Adjust the protective equipment to
the correct height before you start
working.
To do so, detach the clamping screw,
adjust the required height and re-
tighten the clamping screw.
A switch is integrated in the fixture of
the spindle protection which moni-
tors that the cover is closed.
INFORMATION
You cannot start the machine if the
drill chuck protection is not closed.
1.14
Individual protection gear
For certain work individual protection gear as protective equipment. This includes:
Safety helmet,
Protective goggles or face guard,
Protective gloves,
Safety shoes with steel toe caps,
Ear protection.
Before starting work, make sure that the prescribed individual protective equipment is available
in the workplace.
CAUTION!
Dirty or contaminated personnel protective equipment can cause diseases.
Clean your individual protection gear
after each use,
regularly, at least once a week.
Safety
Version 1.1.8 dated 2018-9-13
Protective
cover
Img.1-4:
Protective cover
Clamping screw
Drill chuck
protection
Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
Img.1-5:
Drill chuck protection
®
B16H | B16HV
GB
Page 63