Separating Protective Equipment; Safety Check - Optimum BF20 L Vario Operating Manual

Safety
1.6.3

Separating protective equipment

Adjust the protective equipment to the
correct height before you start working.
To do so, detach the clamping screw,
adjust the required height and retighten
the clamping screw.
A switch is integrated in the fixture of the
spindle protection which monitors that the
cover is closed.
INFORMATION
YOU CANNOT START THE MACHINE IF
THE DRILL CHUCK PROTECTION IS
NOT CLOSED.
1.7

Safety check

Check the drilling-milling machine regularly.
Check all safety devices
before starting work,
once a week (with permanent operation),
after every maintenance and repair operation.
General check
Equipment
Protective covers
Labels,
markings
Run test
Equipment
EMERGENCY-STOP but-
ton
Separating protective
equipment around the
drilling and milling spindle
9 / 03 / 2010
Check
Fitted, firmly bolted and not damaged
Installed and legible
Check
When the EMERGENCY-STOP button is activated, the drilling-
milling machine should switch off. A restart will not be possible
until the EMERGENCY-STOP button has been unlocked and the
ON switch has been activated.
Only switch on the drilling-milling machine if the protective equip-
ment is closed.
Version 3.1.4 BF 20 Vario ; BF 20 L Vario
OPTIMUM
M A S C H I N E N - G E R M A N Y
Locking screw
Fig.1-3: Separating protective equipment
Drilling-Milling machine
OK
OK
Page 11