Separating Protective Equipment; Safety Check - Optimum BF 30 Vario Operating Manual

Safety
1.6.4

Separating protective equipment

Adjust the protective guard equipment to
the correct height before you start work-
ing.
To do so, detach the clamping screw,
adjust the required height and retighten
the clamping screw.
A switch is integrated in the fixture of the
spindle protection which monitors that the
cover is closed.
INFORMATION
YOU CANNOT START THE MACHINE IF
THE PROTECTIVE GUARD IS NOT
CLOSED.
1.7

Safety check

Check the mill drill regularly.
Check all safety advices
at the beginning of each shift,
once a week (with the machine in operation),
after every maintenance and repair operation.
General check
Equipment
Protective covers
Labels,
markings
Run test
Equipment
EMERGENCY-STOP but-
ton
Separating protective
equipment around the
drilling and milling spindle
27 / 08 / 2010
Check
Fitted, firmly bolted and not damaged
Installed and legible
Check
When the EMERGENCY-STOP button is activated, the mill drill
should switch off. A restart will not be possible until the EMER-
GENCY-STOP button has been unlocked and the ON switch has
been activated.
Only switch on the mill drill if the protective equipment is closed.
Version 1.0.6 BF 30 Vario
OPTIMUM
M A S C H I N E N - G E R M A N Y
Locking screw
Fig. 1-4: Separating protective equipment
OK
OK
Mill Drill Page 11