Operation; Starting The Engine; Non-Permitted Starting - Zetor PROXIMA GP Series Operator's Manual

Hide thumbs Also See for PROXIMA GP Series:
Table of Contents

Advertisement

Before a drive with the new tractor get to know how to shift gears and try individual positions
of the shifting lever when the engine is stopped.
During normal operation and before you set up, make sure that the technical condition ensures safe
operation of the tractor.

Starting the engine

After connecting the battery using the battery disconnecting switch, wait at least 30 seconds
before turning on the ignition key.
1 - The operator must sit on the driver's seat when starting the engine.
2 - Brake the tractor with the hand brake.
3 - Insert the key in the switch box - position '0'.
4 - Push down the clutch pedal.
5 - Move the reversing lever to the neutral position.
6 - Move the reversing lever located under the steering wheel to the neutral position.
7 - Make sure that the buttons for activation of the front and rear PTO shafts are not activated (must not be
highlighted).
8 - Switch the key of the switch box from the position '0' to the position 'I'. The glowing signal lamp will be
activated.
9 - Wait until the glowing signal lamp goes out (the time depends on the temperature of the cooling liquid).
In case that the glowing signal lamp only starts flashing instead of glowing, there is a failure in
the glowing system (chapter Indication of glowing system failures). The indicated failure should be
removed in a specialized service centre.
10 - Immediately after the lamp goes out (5 s max.) turn the key from the position 'I' to the position 'II' (start).
11 - After starting the engine, immediately release the key and it is automatically returned to the position 'I'.

Non-permitted starting

It is prohibited to start the tractor by
short-circuiting the terminals of the starter. Perform
starting from the driver's seat only. During any
handling or repair of the starter, the minus pole of the
battery and all gear shift levers, including shifting of
the PTO shaft, must be in the neutral position. The
terminals of the starter are covered with a cover.

OPERATION

PGPPN015
pikt_2
75

Advertisement

Table of Contents
loading

This manual is also suitable for:

Proxima gp 80Proxima gp 90Proxima gp 100Proxima gp 110

Table of Contents